CY8C24894 USB DRIVER DOWNLOAD

Thanks alot, all help would be awesome! Well starting the AV Proggrammer it came up with someting like “wrong version 1. The Manufacturers disclaim all warranties including implied warranties of merchantability or fitness for a particular purpose and are not liable for any damages arising from your use of or your inability to use the Information downloaded from this website. Message 1 of 10 10, Views. Which device did you select while using PSoC Prog. Does it help me to get the job done? The Manufacturers reserve the right to change this Information at any time without notice.

Uploader: Tokree
Date Added: 13 December 2008
File Size: 36.44 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 92373
Price: Free* [*Free Regsitration Required]

Make sure the programming mode is correct.

I somehow have the same issue here. Users browsing this forum: As written in the guide, the programmer gets power through the USB connection. Message 4 of 10 10, Views.

My USB port was neither able to drive both MiniProg and simultanously the avnet pcb, neither it was able to power it through MiniProg, like described in the manual.

The issue was the USB power. Select that Mode and, if the target is powered, then program. Thank you for the replies guys! Check if you have got a probe for your chip.

  DAEWOO DPN-3500 DRIVER DOWNLOAD

Ueb this is the point where I am stuck! You do not have the required permissions to view the files attached to this post. Then is is possible to load the newer 1. Before programming, you will need to toggle the power to turn on the MiniProg. Maximum Operating Supply Voltage. Same for every bus, e.

CY8CLTXAT Price & Stock | DigiPart

The jumper setting is as described in the schematics sheet: Make sure that the device family and part number are correct. Message 1 of 10 10, Views. When starting to program, the MiniProg starts to flash with red LEDs heavily and returns with “cannot aquire I tried lowering communication speed and used drive done pin high in the Xilinx Setup and the it worked. The product does not contain any of the restricted substances in concentrations and applications banned by the Directive, and for components, the product is capable of being worked on at the higher temperatures required by lead—free soldering.

You agree that the Information as provided here through an intermediary may not be error-free, accurate or up-to-date and that it is not advice.

  AMD SEMPRON 2200 SOUND DRIVER DOWNLOAD

I found the document for the Spartan 3A board. Message 7 of 10 8, Views. I have only ISSP connector available: Minimum Operating Supply Voltage.

PSoCDeveloper

But practically it failed. Message 6 of 10 10, Views. This board requires Reset Programming Mode. Board index All times are UTC. Setting the mode to Power Cycle when the us already has external power, results in a “Can’t Acquire Device” error.

PSoCDeveloper • USB RS SPI hub (cy8cltxi)

Does the power jumper on the top right of the board need to be moved to the program position in order to program the PSoC device? I have followed the directions to the dot and have had no luck so far, first cy88c24894 on PSoC programmer 3. ISSP is the programming protocol.