KEIL ULINK-ME DRIVER

Operation not possible while the target device is executing This operation failed or is not possible while the target is running. Firmware is corrupted or cannot be downloaded due to hardware problems. The Debug section controls caching, download, and device reset options applied each time a debug session starts. When this option is set, the debugger does not update memory displays until the next single step, procedure step, or go command executes. Could not stop Cortex-M device The debugger tries to stop the target. Correct the address ranges and ensure they are discrete. This message can also be displayed due to the target’s debug block being improperly powered or clocked for example in deep-sleep mode.

Uploader: Mikazahn
Date Added: 1 February 2012
File Size: 21.96 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 78851
Price: Free* [*Free Regsitration Required]

Not possible while target is executing This operation is not possible or failed while the target is running. Configure Flash Download and add or alter a Programming Algorithm.

ULINK: How to downgrade the firmware of ULINK2/ME

Download the program to Flash. This target device only supports two data access breakpoints Too many data access breakpoints have been defined. The Debug section controls caching, download, and device reset options applied each time a debug session starts.

  IMAGISTICS 3512 DRIVER

Mainly caused by target problems: Stop the target to perform this operation. By default, caching options are enabled to get maximum performance. Refer to Start Sequence for more information. When executing from volatile RAM memory: This is not supported.

This allows you to start a debug session and debug a program that is currently executing on your target. Occurs when more Flash algorithm are defined for an address range.

By continuing to use our site, you consent to our cookies. Correct the address ranges and ensure they are discrete.

Flash Algorithms not in Thumb Code. This site uses cookies to store information on your computer.

ULINK-ME Debug Adapter

Zero Device Size Occurs when the device size is defined as 0 in the Flash algorithm. The Flash algorithm executed on the target did not respond in time Flash algorithm code doesn’t work kdil expected.

The target SWD interface is not working properly. Macro Sequence too long Internal driver error.

Macro Sequence Error Internal driver error. No Algorithm found for: Check if the JTAG interface is working properly. Debug Cannot access Memory Memory on the target cannot be accessed by the debugger.

Please review our Privacy Policy to learn more about our collection, use and transfers of your data. It was not possible to kill all breakpoints Usually occurs when breakpoints cannot be killed while the target is running.

  LG FM776C MONITER DRIVER

ULINK debug and trace adapters

Memory Mismatch Memory mismatch detected while downloading the code to target. The target debug interface is not working properly. Breakpoints Cortex-M It was not possible to disable all breakpoints Occurs when breakpoints cannot be disabled while the target is running.

Avoid Deep-Sleep modes while debugging.

Could not stop ARM device The debugger tries to stop the target. In some uink-me, the target’s debug block not functioning properly raises this error.

Operation not possible while the target device is executing This operation failed or is not possible while the target is running. Rewrite the programming algorithm. This site uses cookies to store information on your computer. This message can also be displayed due to the target’s debug block being improperly powered or clocked for example in deep-sleep mode.